Calculate water evaporation rate from surface area, temperature, humidity, and wind speed with daily loss estimates and cooling power analysis.
The evaporation rate calculator estimates how quickly water evaporates from an open surface based on temperature, humidity, wind speed, and surface area. Evaporation is driven by the vapor pressure deficit — the difference between the saturation vapor pressure at the water surface temperature and the actual vapor pressure of the surrounding air.
This process is critical in water resource management, swimming pool maintenance, cooling tower design, and climate science. A typical outdoor pool can lose 5–10 mm of water per day through evaporation during summer, while industrial cooling towers rely on controlled evaporation to reject heat. Understanding evaporation rates helps predict reservoir levels, design irrigation systems, and estimate water makeup rates for industrial processes.
The calculator uses a mass transfer approach based on the Penman-type equation, incorporating wind speed effects through the empirical relation for the convective mass transfer coefficient. It computes evaporation rate per unit area, total water loss, depth loss per day, and the evaporative cooling power — the energy removed from the water body as latent heat during phase change.
Evaporation rate estimation is critical for pool and spa maintenance, cooling tower makeup water calculations, reservoir water budgets, and agricultural irrigation planning. This calculator gives quick estimates based on easily measured parameters, helping pool owners estimate water costs and engineers size water supply systems. Keep these notes focused on your operational context. Tie the context to the calculator’s intended domain.
Saturation vapor pressure: P_s = 610.78 × exp(17.27T/(T+237.3)) Pa. Vapor pressure deficit: VPD = (P_s − RH×P_s/100). Evaporation flux: E = (25 + 19v) × VPD / L where v = wind speed (m/s), L = latent heat ≈ 2.5 MJ/kg. Depth loss: mm/day = E × 24 × 3600 / ρ.
Result: ~109 L/day (2.2 mm/day depth loss)
A 50 m² pool at 25°C with 50% humidity and 1 m/s wind loses about 109 L/day to evaporation, equivalent to 2.2 mm of water level drop.
Use consistent units, verify assumptions, and document conversion standards for repeatable outcomes.
Most mistakes come from mixed standards, rounding too early, or misread labels. Recheck final values before use. ## Practical Notes
Use concise notes to keep each section focused on outcomes. ## Practical Notes
Check assumptions and units before interpreting the number. ## Practical Notes
Capture practical pitfalls by scenario before sharing the result. ## Practical Notes
Use one example per section to avoid misapplying the same formula. ## Practical Notes
Document rounding and precision choices before you finalize outputs. ## Practical Notes
Flag unusual inputs, especially values outside expected ranges. ## Practical Notes
Apply this as a quality checkpoint for repeatable calculations.
A typical residential pool (40–60 m²) loses 100–300 liters per day depending on temperature, humidity, and wind. Pool covers can reduce this by 90%+.
Significantly. Wind removes the humid boundary layer above the water surface, maintaining a higher vapor pressure deficit. Doubling wind speed can increase evaporation by 50% or more.
VPD is the difference between the maximum water vapor the air can hold (saturation pressure) and what it actually holds. Higher VPD drives faster evaporation.
Higher humidity reduces the vapor pressure deficit, slowing evaporation. At 100% humidity, the air is saturated and net evaporation stops (though microscopic exchange continues).
Each kg of water that evaporates absorbs about 2.45 MJ of latent heat from the surface, cooling it. This is the principle behind swamp coolers, cooling towers, and perspiration.
This uses a simplified mass transfer model. For precise estimates, full Penman-Monteith or CFD models account for solar radiation, long-wave radiation, and detailed boundary layer effects.